article thumbnail

DIY Gamma-Ray Spectroscopy with a Raspberry Pi Pico

Cars That Think

So when I decided to build a cheap DIY scintillating gamma spectrometer, it was the natural choice—although I didn’t realize I’d find myself navigating around teething problems of the sort that often affect a first-generation integrated circuit. This article appears in the July 2022 print issue as “DIY Gamma-Ray Spectroscopy.”.

DIY 102
article thumbnail

Search for Buried Treasure With This DIY Magnetometer

Cars That Think

But feeding it to a second op amp configured as a simple comparator (one that compares the input with zero volts) squared the signal up nicely, with the output switching between the +12-volt and –12-volt supply rails every 3 milliseconds or so. This article appears in the May 2022 print issue as “A DIY Magnetometer.”.

DIY 98
article thumbnail

A Web-Enabled, High Quality, DIY Audio Amp

Cars That Think

November 2018 Hands On article, “DIY Pro Audio ” in IEEE Spectrum , and it convinced me it was possible, although I wanted to go beyond just a power amplifier to something more like my lamented Sansui. In commercial product development, an optimized microcontroller would be the way to go, but for my DIY project, a Pi was perfect.

DIY 100
article thumbnail

A DIY Tracker Tough Enough for the Arctic

Cars That Think

So, I set about building an open-source ice tracker from DIY components that not only proved to be much, much cheaper but also much more capable than the commercial options. This consumed around 350 milliamperes while running at 5 volts for about 1.7 watts, but the Apollo3 uses just 500 microamperes at 3.3 microwatts.

DIY 98
article thumbnail

This Huge DIY Workbench Gives You a Hand

Cars That Think

I added a DIY solder squid—a block with four flexible arms that I use to hold components in place while soldering—with a concrete base and an automatic solder fume extractor. I did just that, pulling out a strip of 12-volt nonaddressable LEDs and powering them with a simple wall power adapter. James Provost. But why stop there?

DIY 104
article thumbnail

A DIY E-bike Conversion on the Cheap

Cars That Think

Here I took advantage of already owning an electric lawnmower, figuring that the 40-volt, 4-ampere-hour battery I had for it would serve well. Being an open-source design no doubt keeps the price of this hardware down: The controller I bought set me back a mere $85. The third essential element of any e-bike is, of course, the battery.

DIY 145
article thumbnail

Chevy Gen 2 Volt 3.6 KW Charger

DIY Electric Car

I have a 2017 Chevy Gen 2 Volt Battery, Charger, DC-DC Converter, coolant pump, 12V current sensor and associated low and high voltage cabling. Chevy Gen 2 Volt 3.6 First up is the on board Charger (Part #24283105). This is an efficient and relatively compact charger. If anyone has. KW Charger.

Volt 130