Green Car Congress

MARCH 8, 2013

The battery, which can be low cost and reliable in terms of safety, provides another chemistry for post Li-ion batteries, they suggest, and with higher practical energy densities than Li-air systems for supporting applications including electric vehicles and large-scale grid energy storage. Higher practical energy density.

Li-ion 281

Li-ion Low Cost Recharge Ni-Li 281

Green Car Congress

NOVEMBER 9, 2011

ITM Power reported that a recently completed three-year collaboration project co-funded by the UK Technology Strategy Board (TSB) resulted in a new alkaline solid polymer membrane for an electrolyzer. Low-cost balance of plant development. Low-cost injection moulded cell plates.

Hydrogen 218

Hydrogen Cost Of Powered Power 218

Green Car Congress

JULY 24, 2017

In a paper in the Journal ChemSusChem they report that using a novel gel polymer electrolyte (GPE) enables stable performance close to the theoretical capacity (1675 mAh g -1 ) of a low cost sulfur-carbon composite with high active material loading, i.e. 70% S. Navarra, M. and Scrosati, B. ChemSusChem doi: 10.1002/cssc.201700977.

Polymer 186

Polymer Li-ion Energy Battery 186

Green Car Congress

MAY 31, 2023

A multi-institutional team led by the US Department of Energy’s (DOE) Argonne National Laboratory (ANL) has developed a low-cost cobalt-based catalyst for the production of hydrogen in a proton exchange membrane water electrolyzer (PEMWE). volts (Nafion 212 membrane) and low degradation in an accelerated stress test.

Low Cost 186

Low Cost Hydrogen Volt 2000 186

Green Car Congress

MAY 14, 2013

The operating and maintenance cost of in-service compressors is exacerbated by the on/off cycling of the compressors resulting from a lack of station demand. The capital cost of the commercial hardware remains high due to low production volumes. Storage Cost Reduction Opportunities. Liquefaction Technologies.

Hydrogen 199

Hydrogen Cost Of Carbon Fiber Low Cost 199

Green Car Congress

FEBRUARY 18, 2020

A consortium of Progressive Energy, Essar, Johnson Matthey, and SNC-Lavalin will deliver the project comprising the development of a 100,000 Nm 3 per hour clean hydrogen production facility for deployment as part of the HyNet Cluster, using Johnson Matthey’s low-carbon hydrogen technology which enables carbon capture and storage.

Hydrogen 386

Hydrogen Carbon Production Wind 386

Green Car Congress

JULY 22, 2012

Cost reduction potential of a polymer fuel cell system using an ITM Power membrane. ITM Power has published figures showing what it believes is the highest ever polymer fuel cell power density using hydrogen as the fuel and ordinary air, rather than pure oxygen. DOE says that 2011 costs are $49/kW. Source: Carbon Trust.

Fuel 250

Fuel Powered Power Polymer 250

Green Car Congress

DECEMBER 2, 2018

a developer of low-cost, high-performance polymers for electrochemical applications, announced its selection by the US Department of Energy’s Advanced Research Projects Agency-Energy (ARPA-E) for an award that will support the continued development of its alkaline exchange ionomers and membranes. 3) Perfluorinated polymers (i.e.,

Fuel 261

Fuel Polymer New York Hydrogen 261

Green Car Congress

OCTOBER 4, 2009

During his presentation at the recent California Air Resources Board (ARB) ZEV Technology Symposium, Tatsuaki Yokoyama, from Toyota Motor Engineering & Manufacturing North America, said that Toyota aimed to reduce the cost of fuel cell vehicles to 1/10 of the current level by design and materials improvement by commercialization in 2015.

2015 315

2015 Toyota Commercial Fuel 315

Green Car Congress

JANUARY 15, 2016

Owing to its high activity and low cost, the catalyst shows significant potential for use in low-cost, high-performance fuel cells, the team suggested. This new hydroxide exchange membrane fuel cell can offer high performance at an unprecedented low cost. —Zhuang et al. —Zhuang et al.

Low Cost 150

Low Cost Fuel Delaware Hydrogen 150

Green Car Congress

SEPTEMBER 11, 2009

The Nitto Denko, Kobe University project is entitled “R&D into Polymer Membrane-integrated System for Distillation and Dehydration of Cellulosic Bioethanol”.

Universal 199

Universal Polymer Low Cost 2009 199

Green Car Congress

SEPTEMBER 2, 2021

The first Energy Earthshot, launched 7 June—Hydrogen Shot—seeks to reduce the cost of clean hydrogen by 80% to $1 per 1 kilogram in 1 decade (“1-1-1”). Achieving the Hydrogen Shot’s $1/kg cost goal will enable new markets for hydrogen, including energy storage, steel manufacturing, clean ammonia, and heavy-duty trucks.

Hydrogen 321

Hydrogen Energy Storage Clean Cleaning 321

Green Car Congress

JANUARY 20, 2017

The process could significantly lower the cost of producing the one-dimensional (1D) nanostructures, enabling a broad range of uses in lightweight structural composites, advanced sensors, electronic devices—and thermally-stable and strong battery membranes able to withstand temperatures of more than 1,000 ˚C. —Gleb Yushin.

Low Cost 150

Low Cost Georgia Li-ion Battery 150

Green Car Congress

SEPTEMBER 17, 2012

The Precourt Institute for Energy, the umbrella organization for energy research and education at Stanford, will fund the following four studies: Nanostructured Polymers for High-Performance Batteries. This project explores the use of specially designed nanostructured polymers to make high-energy, low-cost, flexible and stretchable batteries.

Energy 239

Energy Vehicles Powered Power 239

Green Car Congress

JULY 31, 2020

million from the US Department of Energy (DOE) to develop and validate technology that will reduce the cost of manufacturing high-performance carbon fiber by 25% to make composite natural gas or hydrogen fuel tanks to power cars and trucks. Well over half of the composite fuel tank’s cost is attributed to carbon fiber used in its manufacture.

Carbon Fiber 246

Carbon Fiber Carbon Hydrogen Gas 246

Green Car Congress

SEPTEMBER 30, 2012

The report is specifically focused on the potential for technology from select UK companies to enable a disruptive step-change in fuel cell cost reduction to accelerate consumer uptake, leading to approximately double the number of fuel cell cars on the road globally by 2030 versus current expectations. 500,000 units per year).

Carbon 236

Carbon Fuel Market Polymer 236

Green Car Congress

APRIL 26, 2011

The three companies are conducting a feasibility study to build a succinic acid production facility next to Mitsubishi’s planned polybutylene succinate (PBS, a renewable, biodegradable polymer) production plant in Thailand.

Mitsubishi 186

Mitsubishi Thailand Polymer Low Cost 186

Green Car Congress

MAY 3, 2022

Identify a compelling pathway to a battery cost of. No/low cobalt and no/low nickel-content cathodes [e.g., sulfur-based, highly abundant/low-cost transition metal oxides, halides, sulfides, phosphates, and new organic/inorganic hosts]. maintain area specific resistance (ASR), reduce loss of active material, etc.].

Electric Vehicles 321

Electric Vehicles Batteries Battery Vehicles 321

Green Car Congress

MARCH 19, 2011

The FOA specifies two distinct technical topics: Reducing the Cost of Hydrogen Storage Tanks; and New Materials Discovery. Reducing the Cost of Hydrogen Storage Tanks. greater than 600 ksi ultimate tensile strength) that have costs significantly lower than currently available [1]. kWh to $6/kWh. Currently, high-pressure (i.e.,

Hydrogen 210

Hydrogen Carbon Fiber Low Cost Carbon 210

Green Car Congress

AUGUST 30, 2019

Gigastack, funded by the BEIS Hydrogen Supply Competition, will demonstrate the delivery of bulk, low-cost and zero-carbon hydrogen through gigawatt-scale polymer electrolyte membrane (PEM) electrolysis, manufactured in the UK.

Energy 170

Energy Powered Power Low Cost 170

Green Car Congress

NOVEMBER 22, 2011

A PNNL technology that supports the minimization of high-cost platinum use in polymer electrolyte membrane (PEM) fuel cells was optioned by startup Evaxa Energy Systems , LLC, which intends to incorporate it into a low-cost PEM fuel cell. PEM fuel cells are primarily used for backup power.

America 240

America Building Fuel Batteries 240

Green Car Congress

MAY 19, 2018

AvCarb Material Solutions, LLC: Development of Innovative Gas Diffusion Layers for Polymer Electrolyte Membrane Fuel Cells. Proton exchange membrane fuel cells provide clean energy for applications such as automotive, backup and portable power, but many technical and cost challenges limit their adoption. Techverse, Inc.: Giner, Inc.:

Hydrogen 199

Hydrogen Fuel Low Cost Polymer 199

Green Car Congress

SEPTEMBER 14, 2016

Solid ion conductors made of affordable, easily produced materials could replace today’s mostly liquid electrolytes and expensive fuel cell parts, helping create a next generation of batteries and fuel cells that are low-cost, durable, and more efficient. Novel Polymer Electrolyte for Solid State Lithium Metal Battery Technology.

Li-ion 150

Li-ion Polymer Batteries Battery 150

Green Car Congress

NOVEMBER 28, 2021

Sepion raised funds to accelerate commercialization of lithium metal batteries for long-range and low-cost electric vehicles. The $16-million funding round was led by Fine Structure Ventures, and also includes other climate tech investors. —Mike Finelli, President of Growth Initiatives at Solvay.

Li-ion 259

Li-ion Battery Batteries Companies 259

Green Car Congress

NOVEMBER 11, 2014

Teijin Limited is developing a non-platinum carbon alloy catalyst (CAC) for the cathode oxygen reduction reaction (ORR) in polymer electrolyte fuel cells. Less expensive and more readily available than platinum, PAN enables the catalyst to be produced at reduced cost and in higher volumes. —Chai et al. 2010.01.012.

Carbon 210

Carbon Fuel Polymer Production 210

Green Car Congress

JANUARY 18, 2014

As described in multiple DOE reports, the main barriers to widespread PEV commercialization are the cost; performance and life; and abuse tolerance of high?energy Specifically: the current cost of high?energy Most critical is the cost of the carbon fiber. per pound of weight saved, which could include very low?cost

Carbon Fiber 252

Carbon Fiber Engine Battery Powered Fuel 252

Green Car Congress

JULY 2, 2017

Department of Energy (DOE) grant to continue their research in developing low-cost, high-strength carbon fiber. The center’s Carbon Materials Technologies Group received the award for a project titled “Precursor Processing Development for Low Cost, High Strength Carbon Fiber for Composite Overwrapped Pressure Vessel Applications.”

Carbon Fiber 150

Carbon Fiber Kentucky Carbon Low Cost 150

Green Car Congress

MARCH 22, 2012

Polymer electrolyte membrane fuel cells (PEMFCs) are being developed worldwide as clean energy conversion devices. Long-Lived, High-Energy-Density and Low-Cost Lithium-Ion Batteries for Automotive, Grid Energy and Medical. These university-industry partnerships will receive almost $34 million in total project support.

Canada 262

Canada Li-ion Fuel Battery 262

Green Car Congress

JUNE 7, 2013

FCTO anticipates that the FOA may include the following Topic Areas: Topic Area 1: Reducing the Cost of Compressed Hydrogen Storage Systems. Topic 1 will focus on the development of complete, low-cost, compressed hydrogen storage systems. kWh when manufactured in high volume; and. Hydrogen Storage'

Hydrogen 199

Hydrogen Carbon Fiber Low Cost Powered 199

Green Car Congress

SEPTEMBER 16, 2016

The funds will be used to develop novel membranes and lithium-metal anodes for the next generation of high-energy-density, low-cost batteries. The company has developed a microporous polymer membrane to replace incumbent separator materials. Click to enlarge.

Li-ion 150

Li-ion Lithium Ion Energy Polymer 150

Green Car Congress

SEPTEMBER 18, 2012

This newly acquired SGI technology includes methods for highly parallelized, low-cost oligonucleotide synthesis and retrieval of sequence-validated DNA. All related know-how, equipment and technical support for implementation, were also purchased. Craig Venter, Ph.D., Founder and CEO, SGI.

Purchase 218

Purchase 2005 Polymer Water 218

Green Car Congress

AUGUST 14, 2018

Selections for this investment focus on key early-stage technical challenges related to non-precious metal catalysts; fuel cell membranes; reversible fuel cells; and electrolyzers to produce hydrogen, as well as innovative concepts to improve efficiency and lower costs of hydrogen vehicle refueling infrastructure. 1,997,216. .: 1,000,000.

Hydrogen 186

Hydrogen Fuel Universal Polymer 186

Green Car Congress

AUGUST 7, 2020

REPAIR teams will develop technology that enables gas utilities to update their distribution systems at low cost and continue to reliably service commercial and residential gas delivery needs nationwide. The designed polymer composite coating materials provide structural strength and facile processability with smart functionalities.

Gas 297

Gas Gas-Electric Universal Colorado 297

Green Car Congress

JANUARY 13, 2021

This proposed project will significantly (1) reduce Si anode costs; (2) improve efficiency and reduce waste in production; (3) reduce engineering and cost risks; and (4) reduce EV battery costs and accelerate the move to clean transportation and renewable energy. 24M Technologies, Inc. Cambridge Electronics, Inc.

Li-ion 199

Li-ion Battery Batteries Lithium Ion 199

Green Car Congress

JUNE 6, 2014

DOE is inviting applications for novel cathode Platinum Group Metal (PGM)-free catalysts for the oxygen reaction and PGM-free cathode membrane electrode assemblies (MEAs) for low-temperature and high-temperature polymer electrolyte membrane fuel cells (PEMFCs) and phosphoric acid fuel cells (PAFCs). Hydrogen infrastructure (TRL 9-10).

Hydrogen 231

Hydrogen Fuel Polymer Renewable 231

Green Car Congress

DECEMBER 4, 2010

One area where metabolic engineering has a sizable advantage over synthetic organic chemistry is in the production of natural products, particularly active pharmaceutical ingredients (APIs), some of which are too complex to be chemically synthesized and yet have a value that justifies the cost of developing a genetically engineered microorganism.

Engine 239

Engine Design Fuel Polymer 239

Green Car Congress

MARCH 10, 2018

A) SEM image of the CNT membrane surface, showing CNT tips emerging from the polymer. The difficulty and high cost of making CNT membranes has confined them to university laboratories and has been frequently cited as the limiting factor in their widespread use. Images of the membranes tested in the study. (A)

Carbon 199

Carbon Fuel Polymer Austin 199