Green Car Congress

DECEMBER 9, 2010

Like all plastics, the new material is a polymer—a large molecule comprising smaller, repeating units called monomers. The units are called omega-hydroxyfatty acids, and when strung together to form a polymer, they can produce a biologically friendly plastic. The monomer itself is relatively new. Wenhua Lu, Jon E.

Conversion 252

Conversion Polymer Oil New York 252

Green Car Congress

JANUARY 20, 2017

In a paper in the journal Science , the team reported the transformation of multimicrometer-sized particles of aluminum or magnesium alloys into alkoxide nanowires of tunable dimensions, which were converted into oxide nanowires upon heating in air. —Lei et al. The dissolved lithium can be recovered and reused. —Gleb Yushin.

Low Cost 150

Low Cost Georgia Li-ion Battery 150

Green Car Congress

JUNE 26, 2020

The IDEALFUEL project aims to create sustainable alternatives by developing new efficient and low-cost methods to produce low-sulfur heavy fuel oils from wood-based non-food biomass. Although cleaner fuels are available, many companies opt for HFOs due to their low cost.

Mariner 273

Mariner Oil Fuel Cleaner 273

Green Car Congress

AUGUST 29, 2015

an integrated stationary fuel cell manufacturer, to develop a durable, low-cost, and high-performance electrochemical cell to convert natural gas and other methane-rich gas into methanol, a major chemical commodity with worldwide applications in the production of liquid fuels, solvents, resins, and polymers. Earlier post.)

Convert 150

Convert North Dakota Gas Fuel 150

Green Car Congress

OCTOBER 9, 2014

The following Stanford faculty members received funding for advanced research on photovoltaics, battery technologies and new catalysts for sustainable fuels: Self-healing polymers for high energy density lithium-ion batteries. The mineral perovskite is a promising, low-cost material for enhancing the efficiency of silicon solar cells.

Renewable 225

Renewable Solar Zinc Air Fuel 225

Green Car Congress

MAY 23, 2013

Intended primarily to convert heavy fuel oil into desulfurized diesel and ultra low sulfur heating oil, the planned complex responds to the shift in demand toward products with a lower environmental impact. The facility is scheduled to start up in early 2016.

Production 186

Production Polymer Oil Convert 186

Green Car Congress

NOVEMBER 16, 2018

Ecolectro is developing alkaline exchange ionomers (AEIs) to enable low-cost fuel cell and electrolyzer technologies. Novel Polymer-enhanced Rechargeable Aluminum-Alkaline Battery Technology – $2,000,000. Stable Diacid Coordinated Quaternary Ammonium Polymers for 80-230 °C Fuel Cells – $2,900,000. Ionic Materials, Inc.

Engine 247

Engine San Diego Polymer Lithium Ion 247

Green Car Congress

SEPTEMBER 2, 2011

Low Cost, Scalable Low Rare Earth Electric Motor. High temperature converters - fast track to increasing the speed of adoption of electric powertrains. T&L Process Technology Ltd (lead), Brunel University, Jaguar Land Rover, Dupont Performance Polymers, Axion Recycling Ltd. Light and Sound (LANDS).

Land Rover 240

Land Rover Carbon Aston Martin Vehicles 240

Green Car Congress

APRIL 18, 2017

Researchers at the University of Minnesota have developed and demonstrated at laboratory scale a novel process to synthesize low-cost, polymeric valerolactones with tunable mechanical properties and low glass transition temperatures. Their production and disposal is therefore unsustainable in the long term.

Polymer 150

Polymer Minnesota Universal Renewable 150

Green Car Congress

MAY 3, 2012

The syrup was then processed by Amyris at its California pilot facility using its proprietary yeast fermentation system that converts plant sugars into its trademarked product, Biofene, a renewable hydrocarbon commonly known as farnesene. As an energy crop, sweet sorghum is an impressive producer of low-cost, fermentable sugars.

Renewable 236

Renewable Diesel Hawaii Louisiana 236

Green Car Congress

JULY 29, 2015

tons of low-cost, industrial-grade sugar for 1 ton of high-purity high-value bio-isobutene. Isobutene is a key chemical building block that can be converted into transportation fuels, polymers and various commodity chemicals. The targeted commercial yield is 3.84 This is a huge milestone.

Commercial 150

Commercial Global Polymer Low Cost 150

Green Car Congress

FEBRUARY 15, 2022

The new superjunction structure will surpass the theoretical trade-off between on- resistance and breakdown voltage observed in conventional unipolar GaN, leading to more efficient and cheaper power converters. The Ohio State University. Ionomer-Free Electrodes for Ultrahigh Power Density Fuel Cells - $3,220,310. University of Washington.

Clean 284

Clean Cleaning Energy Li-ion 284

Green Car Congress

JUNE 4, 2012

Edeniq’s Cellunator enables plants to mill corn and other plant materials into small, uniform pieces of feedstock that can be converted into sugars needed to produce biofuels. This collaboration with Flint Hills Resources Renewables demonstrates our mission of accelerating low-cost cellulosic ethanol to market.

Renewable 170

Renewable Fort Worth Iowa Minnesota 170

Green Car Congress

MAY 19, 2014

Potential high-value products from isolated lignin include low-cost carbon fiber, engineering plastics and thermoplastic elastomers, polymeric foams and membranes, and a variety of fuels and chemicals—all currently sourced from petroleum. Ragauskas et al. courtesy of Oak Ridge National Laboratory.] Click to enlarge.

Production 225

Production Carbon Fiber Polymer Fuel 225

Green Car Congress

OCTOBER 26, 2009

Eagle Picher, in partnership with the Pacific Northwest National Laboratory, will develop a new generation of high energy, low cost planar liquid sodium beta batteries for grid scale electrical power storage applications. Low Cost, High Energy and Power Density, Nanotube-Enhanced Ultracapacitors. DOE grant: $7,200,000).

Energy 231

Energy Grant Low Cost Li-ion 231

Green Car Congress

OCTOBER 14, 2010

Avantium uses a catalytic process to convert carbohydrates into furanics building blocks. Over the past years we have made tremendous progress to develop a low-cost production process to convert biomass into YXY building blocks. Click to enlarge. —Tom van Aken, CEO Avantium.

Building 186

Building Netherlands Convert 2000 186

Green Car Congress

NOVEMBER 25, 2013

The US Department of Energy (DOE) Advanced Research Projects Agency - Energy (ARPA-E) will award up to $30 million to fund a new program focused on the development of transformational electrochemical technologies to enable low-cost distributed power generation. DE-FOA-0001026 ). Source: ARPA-E. Click to enlarge. Source: ARPA-E.

Fuel 231

Fuel Powered Power Gas-Electric 231

Green Car Congress

MARCH 22, 2012

Polymer electrolyte membrane fuel cells (PEMFCs) are being developed worldwide as clean energy conversion devices. Long-Lived, High-Energy-Density and Low-Cost Lithium-Ion Batteries for Automotive, Grid Energy and Medical. GM Canada, and Hydrogenics. APC Investment: $4,176,005 (through NSERC and CFI).

Canada 262

Canada Li-ion Fuel Battery 262

Green Car Congress

AUGUST 27, 2011

The process was able to convert aqueous carbohydrate streams derived from maple wood (produced using both hot water and acid hydrolysis) into gasoline-range products with carbon yields of up to 57% and an estimated octane number of 96.5.

Gasoline 257

Gasoline Renewable Production Water 257

Green Car Congress

JULY 17, 2020

AOI 02: Low Cost Electric Traction Drive Systems Using No Heavy Rare Earth Materials. Low Cost, High-Performance, Heavy Rare Earth-Free 3-In-1 Electric Drive Unit. Low-Cost Rare-Earth Free Electric Drivetrain Enabled by Novel Permanent Magnets, Inverter, Integrated Design and Advanced Thermal Management.

Lithium Ion 236

Lithium Ion Vehicles Li-ion Universal 236

Green Car Congress

AUGUST 23, 2017

HRL achieved a scientific breakthrough with pre-ceramic resins that can be 3D printed and converted to high-temperature ceramic that was first published in the journal Science on 1 January 2016.

Engine 150

Engine Polymer General Motors Low Cost 150

Green Car Congress

APRIL 30, 2010

Today’s technologies for making biofuels all rely on photosynthesis—either indirectly by converting plants to fuels or directly by harnessing photosynthetic organisms such as algae. This process is less than 1% efficient at converting sunlight to stored chemical energy. Electrofuels: Biofuels from Electricity. Engineering E.

Carbon 249

Carbon Li-ion Batteries Battery 249

Green Car Congress

SEPTEMBER 28, 2015

By employing proprietary pretreatment and processing, researchers at Oak Ridge National Laboratory and Drexel University have produced flexible polymer carbon composite films from scrap tires for use as electrodes for supercapacitors. 2015) “Waste Tire Derived Carbon–Polymer Composite Paper as Pseudocapacitive Electrode with Long Cycle Life.”

Polymer 150

Polymer Waste Carbon Low Cost 150

Green Car Congress

JANUARY 18, 2014

VTO is seeking projects in this area not represented by, or similar to, current R&D projects at DOE) that focus on the following key barriers: Cost Reduction. The additional content which includes the motor, inverter, converter, and on?board board charger must be offset by the cost savings in operational costs as seen by the customer.

Carbon Fiber 252

Carbon Fiber Engine Battery Powered Fuel 252

Green Car Congress

MARCH 10, 2018

A) SEM image of the CNT membrane surface, showing CNT tips emerging from the polymer. It consists of a carbon nanotube fixed within a flexible polymer sheet and aligned so that both of its ends are open. Dr. Freeman’s research is in polymer science and engineering specifically in mass transport of small molecules in solid polymers.

Carbon 199

Carbon Fuel Polymer Austin 199

Green Car Congress

APRIL 6, 2018

The design method, reported in a paper in the Proceedings of the National Academy of Sciences , (PNAS) also has the potential to impact the discovery of new optical and data storage materials, catalysts that impact pharmaceutical synthesis and catalysts that allow for higher efficiency processing of petroleum products at much lower cost.

Design 191

Design Chad Polymer Conversion 191

Green Car Congress

MAY 25, 2017

This proposal aims to solve these problems by converting organic waste into chemicals with widespread use in polymer and transportation industries. This project focuses on the development and US manufacturing of a new battery membrane that enables low-cost and long-lived Li-ion batteries. Trash2Cash-Energy LLC.

Grant 150

Grant Li-ion Waste Lithium Sulfur 150

Green Car Congress

SEPTEMBER 6, 2019

Each module uses a bi-directional DC/DC converter to deliver high energy and high power density, including the transfer of energy between the two types of cell (e.g., This unique production process creates an engineered hinge embedded within a single composite preform of carbon fiber reinforced polymer (CFRP).

Engine 191

Engine Batteries Battery Carbon Fiber 191

Green Car Congress

DECEMBER 22, 2010

Under the program, the grantees will be expected to conduct life cycle cost analyses for different manufacturing volumes to help gauge the near-term, low-volume market viability for these technologies, along with their long-term potential. desulfurization); reactors to convert the raw fuel into a hydrogen-rich stream (e.g.,

Fuel 218

Fuel Hydrogen Low Cost Transportation 218

Green Car Congress

JUNE 16, 2009

In this role, Ryan will be responsible for business development in converting isobutanol into chemicals, jet fuel, gasoline, diesel, and fuel blendstocks. Chris Ryan has joined the Gevo as Vice President of Business Development-Downstream. Gevo was founded in 2005 by Drs.

Renewable 150

Renewable Building Gasoline 2005 150

Green Car Congress

MAY 10, 2018

Elemental sulfur, as one of promising cathode materials, can offer a theoretical capacity of 1672 mAh g -1 and high energy density of 2600 W h kg -1 at a low cost, when it is coupled with metallic Li anode.

Lithium Sulfur 186

Lithium Sulfur Batteries Battery Engine 186

Green Car Congress

NOVEMBER 2, 2011

First, it can accommodate the significant volume changes of S as it is converted to Li 2 S on discharge, and back to elemental S on recharge. The team concludes that the same design strategy could be helpful to explore and develop new porous carbon or conductive polymer-based sulfur nanocomposite cathodes for advanced Li/S cells.

Lithium Sulfur 186

Lithium Sulfur Li-ion Battery Batteries 186

Green Car Congress

NOVEMBER 13, 2009

for an award of up to $1,200,000 to further its development of Biomass-to-Gasoline (BTG) technology—a novel thermochemical process that converts biomass into a clean, high-octane gasoline-compatible fuel. It also has developed ExSyM, a new low-cost styrene monomer production technology based on new chemistry. ARPA-E Award.

Gasoline 170

Gasoline Convert Waste Conversion 170

Green Car Congress

JUNE 19, 2013

Calysta Energy and NatureWorks have entered into an exclusive, multi-year collaboration to research and develop a practical production process for fermenting methane into lactic acid, the building block for Ingeo , lactide intermediates and polymers made from renewable materials.

Building 170

Building Energy Asia Waste 170

Green Car Congress

DECEMBER 13, 2019

Low-cost electric traction drive systems using no heavy rare earth materials. The objective of this potential area of interest is to research, develop, and test a heavy rare earth mineral free advanced motor and inverter drive system that costs ?

2020 186

2020 Vehicles Polymer Gasoline-Electric 186

Green Car Congress

JUNE 1, 2015

While some specially designed 3D porous graphene networks show good pore connectivity and conductivity, large-scale and low-cost fabrication of such graphene networks remains a challenge. The process begins with conducting hydrogel, a water-based polymer with a spongy texture similar to soft contact lenses.

Energy Storage 150

Energy Storage Carbon Lithium Sulfur Energy 150

Green Car Congress

MAY 13, 2016

Combing these benefits with a low-cost precursor currently in development, the result can be a carbon fiber product that is 40% less expensive to manufacture than current commercial products. During oxidation, the thermoplastic precursor is converted to a thermoset material that can no longer be melted.

Carbon Fiber 150

Carbon Fiber Carbon Energy Production 150