Green Car Congress

AUGUST 14, 2013

LanzaTech, a producer of low-carbon fuels and chemicals from waste gases, has partnered with the Centre for Advanced Bio-Energy, a joint venture between Indian Oil Corporation, Ltd. LanzaTech has developed gas fermentation technology that can directly convert waste CO 2 gases into acetates. CO 2 to acetic acid fermentation.

Waste 199

Waste Fuel India Energy 199

Green Car Congress

MARCH 26, 2021

The biocrude oil came from many different sources, including wastewater sludge from Detroit, and food waste collected from prison and an army base. The research showed that essentially any biocrude, regardless of wet-waste sources, could be used in the process and the catalyst remained robust during the entire run.

Diesel 332

Diesel Waste Convert Washington 332

Green Car Congress

OCTOBER 18, 2020

BOTTLE Consortium Collaborations to Tackle Challenges in Plastic Waste: Create collaborations with the BOTTLE Laboratory Consortium to further the long-term goals of the Consortium and the Plastics Innovation Challenge. Skokie, IL) - Upscaling of Non-Recyclable Plastic Waste into CarbonSmart Monomers – DOE Funding: $1,890,001.

San Diego 321

San Diego San Jose Iowa Oklahoma 321

Green Car Congress

JUNE 3, 2023

Made from sustainably sourced, 100% renewable raw materials such as used cooking oil and animal fat waste, the use of Neste MY Renewable Diesel can reduce greenhouse gas emissions by up to 75% over the life cycle of the fuel compared to fossil diesel. Rio Tinto US Borax used Neste MY Renewable Diesel during the trial. billion gallons (5.5

Renewable 221

Renewable Diesel Singapore California 221

Green Car Congress

FEBRUARY 1, 2019

Furthermore, Eni and Pertamina agreed to explore and discuss collaboration in the field of recycle and re-use: water treatment and re-use processes and polymer recycling technologies, also pursuing eco-design processes to maximize final products recycle.

Renewable 230

Renewable Indonesia Carbon Production 230

Green Car Congress

FEBRUARY 7, 2019

These runs were part of OPTISOCHEM (OPTimized conversion of residual wheat straw to bio-ISObutene for bio based CHEMicals), a project which started in June 2017 and was granted €9.8 million by the Bio Based Industry- Joint Undertaking (BBI-JU) as part of the H2020 program. The R&D cooperation will continue until May 2021.

Production 186

Production France Polymer Conversion 186

Green Car Congress

MARCH 4, 2022

It’s also often produced using corn and other crop feedstocks, but this approach is dependent on crops that otherwise could be used to grow food or waste feedstocks. Polypropylene is a major polymer used in key applications, including medical devices like syringes and IV bags, automotive, furniture, textiles, and other durable products.

Convert 324

Convert CO2 Carbon Polymer 324

Green Car Congress

APRIL 9, 2020

Fuel cells, especially polymer electrolyte membrane fuel cells (PEMFC), are already used in hydrogen-powered automobiles. General recycling processes for precious metals that are currently in use are also designed for these metals, in which polymer electrolyte membrane fuel cells are currently largely processed.

Fuel 243

Fuel Polymer Hydrogen Design 243

Green Car Congress

JANUARY 27, 2023

The goal of the project is to continue to develop a circular carbon economy that replaces the petroleum-based chemicals in consumer products with algae-derived and biodegradable polymers. This project will demonstrate the conversion of gaseous carbon wood wastes (terpenes) to renewable Terpenes SAF blending components.

Production 225

Production Carbon Conversion Fuel 225

Green Car Congress

MAY 25, 2017

Production of C 5 hydrocarbons from waste biomass. Obtaining sustainable sources of chemicals and processing organic waste in an environmentally responsible manner remains a challenge. This proposal aims to solve these problems by converting organic waste into chemicals with widespread use in polymer and transportation industries.

Grant 150

Grant Li-ion Waste Lithium Sulfur 150

Green Car Congress

JUNE 13, 2018

By re-using waste streams instead of incinerating them, industrial companies can reduce carbon dioxide emissions. Ethanol can be used as the raw material for the production of diesel, gasoline or jet fuel and as a precursor to plastics and polymers. Earlier post.) Earlier post.)

Waste 223

Waste Carbon Polymer Convert 223

Green Car Congress

DECEMBER 11, 2020

This topic includes two focus areas to reduce the cost and enhance the durability and performance of Polymer Electrolyte Membrane (PEM) fuel cell stacks for heavy-duty applications. The second focus area supports technology development which enables low cost hydrogen production via waste and biomass conversion.

Hydrogen 321

Hydrogen Fuel Low Cost Idaho 321

Green Car Congress

AUGUST 22, 2019

The complete Blue World system includes the fuel cell stack, the methanol reformer, heat-exchanger, power conversion units and a set of power and operation controllers, and balance of plant. A closed thermal integration enables reuse of fuel cell waste heat for fuel evaporation thereby increasing efficiency.

Fuel 317

Fuel Power Powered Waste 317

Green Car Congress

JULY 31, 2019

Australia-based biotechnology company Circa Group, which produces its bio-based solvent Cyrene from waste cellulose, is participating in a project to develop the first UK industrial scale capability to reclaim and reuse the most valuable components of end-of-life electrical vehicle (EV) batteries. straw, bagasse, sawdust).

Batteries 186

Batteries Battery Polymer Li-ion 186

Green Car Congress

JULY 3, 2020

The three-member team used a membrane-electrode assembly in which the polymer bipolar membrane is compressed between two rigid porous electrodes, allowing them to make a large number of bipolar membranes with different water dissociation catalyst layers. —Sebastian Oener.

Oregon 284

Oregon Water Polymer Hydrogen 284

Green Car Congress

JUNE 26, 2020

IDEALFUEL seeks to develop methods to convert woody residual and waste materials such as sawdust and wood chips into renewable marine fuels. The concept describes the conversion of lignin—the polymer found in the structural materials of plants and trees—from dry lignocellulosic biomass into renewable fuels.

Mariner 273

Mariner Oil Fuel Cleaner 273

Green Car Congress

JULY 22, 2010

Novomer will develop a process for converting waste CO 2 into a number of polycarbonate products (plastics) for use in the packaging industry. Novomer’s novel catalyst technology enables CO 2 to react with petrochemical epoxides to create a family of thermoplastic polymers that are up to 50% by weight CO 2. Alcoa, Inc.

Conversion 225

Conversion CO2 San Antonio Carbon 225

Green Car Congress

JANUARY 11, 2017

It will extend our capabilities beyond catalytic conversion of biomass. This acquisition will enable the development of a powerful technology platform on the basis of CO 2 feedstock, meaning it turns waste into valuable products such as chemicals and plastics. —Tom van Aken, CEO of Avantium.

Light 150

Light Convert CO2 Polymer 150

Green Car Congress

FEBRUARY 12, 2018

Argonne National Laboratory’s team will develop an advanced catalyst for polypropylene (a widely used polymer in consumer and industrial products) synthesis that outperforms conventional catalysts. Bio2Electric, LLC d.b.a. EcoCatalytic Technologies. Colorado State University. Dana-Farber Cancer Institute. FeNix Magnetics, Inc. 2,089,647.

Manufacturer 150

Manufacturer Waste Universal Dallas 150

Green Car Congress

DECEMBER 3, 2016

Researchers at Washington State University Tri-Cities have been awarded a $50,000 National Science Foundation I-Corps grant to explore the commercialization potential of their new pathway for biojet from biomass waste. Earlier post.). Earlier post.).

Grant 150

Grant Market Washington Waste 150

Green Car Congress

MAY 4, 2018

This FOA addresses gaps in current research and development (R&D) which hinder better utilizing waste streams (e.g. led research and development consortium dedicated to identifying and overcoming catalysis challenges for biomass conversion processes. Topic Area 4: Biofuels and Bioproducts from Wet Organic Waste Streams.

Waste 170

Waste Renewable Conversion Carbon 170

Green Car Congress

OCTOBER 17, 2012

In a presentation at the 1 st Conference on CO 2 as Feedstock , held last week in Essen, Germany, LanzaTech CSO Dr. Part of the challenge is locating sufficient quantities of hydrogen to enable large scale use of the CO 2 in waste gases. that conversion wouldn’t actually happen in a LanzaTech bioreactor. Earlier post.). Resources.

Parts 244

Parts CO2 Renewable Conversion 244

Green Car Congress

MAY 16, 2016

Novomer is commercializing a proprietary catalyst system that transforms waste CO 2 into high performance, low-cost polymers for a variety of applications, including foam and plastic that are easily recyclable. These polymers contain up to 50% CO 2 by mass. Low Finished Polymer Cost. Among these companies is Novomer.

Ford 150

Ford Polymer CO2 Vehicles 150

Green Car Congress

MARCH 12, 2019

This wood passes through the beetle’s complex digestive tract and is finally excreted as its waste product, politely termed frass. In the midgut (MG), plant polymers are changed into simpler components, which are then fermented in the anterior hindgut (AHG), where nitrogen is fixed and methane and hydrogen produced.

Production 255

Production Fuel South Carolina Hydrogen 255

Green Car Congress

JANUARY 21, 2012

By contrast to other processes, our membrane technology needs no auxiliary chemicals; nor does it generate any solid wastes or effluents that would need to be disposed of. The technology is based on membranes produced from high-performance polymers that in the past have been processed into fibers and used in hot-gas filtration.

Gas 218

Gas Energy Austria Grid 218

Green Car Congress

NOVEMBER 23, 2011

In a paper earlier this year describing a new mixed oxide catalyst for the direct conversion of bio-ethanol to isobutene, researchers from the Pacific Northwest National Laboratory (PNNL) noted that trimerization of isobutene produces tri-isobutenes, which can be used as an additive for jet fuel. Jennifer Holmgren, LanzaTech CEO.

Carbon 199

Carbon Global Waste New Zealand 199

Green Car Congress

OCTOBER 15, 2012

LanzaTech, a producer of low-carbon fuels and chemicals from waste gases, and Petronas, the national oil company of Malaysia, will work together to accelerate the development and commercialization of technologies to produce sustainable fuels and chemicals using CO 2 as the carbon source. LanzaTech conceptual gas-to-liquids platform.

Malaysia 268

Malaysia CO2 Carbon Oil 268

Green Car Congress

JULY 14, 2015

This has led to improved biofuel productivity, higher economic returns, minimal waste production, and a lower carbon footprint. carbon fixation), such that the energy of the excess photons is wasted through non-photosynthetic processes. When they cannot be utilized efficiently they are wasted, normally through venting or flaring.

EPA 150

EPA Green Polymer Water 150

Green Car Congress

MARCH 30, 2014

Assistant professor Niels Holten-Andersen of the Department of Materials Science and Engineering and assistant professor Jeremiah Johnson of the Department of Chemistry are working to combine metallosupramolecular assembly with polymer networks to create a new class of hybrid metal-organic materials.

MIT 210

MIT Grant 2014 Energy 210

Green Car Congress

JULY 16, 2013

The conventional way to make gasoline from gas is to convert the gas to a synthesis gas, then into methanol, followed by conversion to straight-chain hydrocarbons and finally via reforming into a high-octane hydrocarbon blend. This method of conversion is much more effective and cheaper than the traditional method. Jean-Marie Bassett.

Convert 230

Convert Gasoline Gas Commercial 230

Green Car Congress

OCTOBER 22, 2010

Immediate applications include processing municipal sewage sludge, processing waste streams from the ethanol industry and converting algae to fuel. We use hot water to depolymerize the cellulose, lignins, lipids and other polymers contained in the biomass. Our process is similar to that used by several companies worldwide.

Oil 199

Oil Gasoline Commercial Conversion 199

Green Car Congress

AUGUST 19, 2023

plans to develop a novel membrane system from Osmoses’ proprietary polymer composition that can produce enriched oxygen from air for integration into modular gasification systems for low-cost hydrogen production. The team intends to demonstrate high-purity (greater than 98% by volume, preferably above 99.5%

Hydrogen 150

Hydrogen Clean Cleaning Gas-Electric 150

Green Car Congress

MARCH 14, 2017

The system operates under visible light, is stable beyond six days and is even able to reform unprocessed lignocellulose, such as wood and paper, under solar irradiation at room temperature, presenting an inexpensive route to drive aqueous proton reduction to H 2 through waste biomass oxidation.

Light 236

Light Solar Conversion Hydrogen 236

Green Car Congress

JULY 8, 2011

The funds will be used to start the industrialization of the company’s process to convert renewable resources into isobutene, a gas which can be converted into liquid fuels and various polymers. straw) into isobutene, one of the key building blocks of the petrochemical industry.

Industry 186

Industry Industrial Global Polymer 186

Green Car Congress

DECEMBER 31, 2016

Additionally, many chemicals relied upon for transportation (such as oils and lubricants) as well as other commodity chemicals and polymer precursors are, and will likely remain, carbon-based. By 2040, enable large-scale biomass production and conversion that allows biofuels to constitute 25% of the US transportation fuel market.

Transportation 207

Transportation Fuel Conversion Water 207

Green Car Congress

MAY 19, 2014

This can happen either after removal of most of the carbohydrates by hydrolysis and fermentation operations (top sequence) or by pretreatment before downstream carbohydrate conversion (bottom sequence). Ragauskas et al. courtesy of Oak Ridge National Laboratory.] Click to enlarge. —Arthur Ragauskas.

Production 225

Production Carbon Fiber Polymer Fuel 225

Green Car Congress

MARCH 10, 2010

Through the introduction of organic catalysis to synthetic polymer chemistry, scientists have developed a broadly applicable technology with demonstrations in a diverse range of polymerization techniques and monomer types. Waymouth (2010) Organocatalysis: Opportunities and Challenges for Polymer Synthesis. Hedrick and Robert M.

Universal 199

Universal Polymer United States Waste 199