This site uses cookies to improve your experience. To help us insure we adhere to various privacy regulations, please select your country/region of residence. If you do not select a country, we will assume you are from the United States. Select your Cookie Settings or view our Privacy Policy and Terms of Use.
Cookie Settings
Cookies and similar technologies are used on this website for proper function of the website, for tracking performance analytics and for marketing purposes. We and some of our third-party providers may use cookie data for various purposes. Please review the cookie settings below and choose your preference.
Used for the proper function of the website
Used for monitoring website traffic and interactions
Cookie Settings
Cookies and similar technologies are used on this website for proper function of the website, for tracking performance analytics and for marketing purposes. We and some of our third-party providers may use cookie data for various purposes. Please review the cookie settings below and choose your preference.
Strictly Necessary: Used for the proper function of the website
Performance/Analytics: Used for monitoring website traffic and interactions
In a paper in Nature , they suggest that the use of such redox-active organic molecules instead of redox-active metals represents a new and promising direction for realizing massive electrical energy storage at greatly reduced cost. The design permits larger amounts of energy to be stored at lower cost than with traditional batteries.
The new battery design could help ease integration of renewable energy into the electrical grid at lower cost, using Earth-abundant metals, according to a study just published in Energy Storage Materials. h is achieved with an estimated raw active materials cost of $7.02 mAh cm −2 , a discharge duration of 28.2 Weller et al.
Under the FOCUS program, projects will develop advanced solar converters that turn sunlight into electricity for immediate use, while also producing heat that can be stored at lowcost for later use as well as innovative storage systems that accept both heat and electricity from variable solar sources. Earlier post.).
The primary goal of this funding opportunity ( DE-FOA-0000949 ) is to provide disruptive new solar conversion and storage technology options to enable a much higher penetration of solar energy generation into the US energy mix. The FOCUS Program target zone for electricity generation is indicated. Source: ARPA-E. Click to enlarge.
MHI), jointly with SSE plc (formerly Scottish and Southern Energy plc), will begin an energy storage system demonstration project using the power grid in the UK’s Orkney Islands, which has a high proportion of renewable energy generation in relation to demand. Mitsubishi Heavy Industries, Ltd.
Under the three-year program, Eaton will develop and demonstrate a novel, compact and turnkey solution for DC fast-charging infrastructure that is anticipated to reduce costs by 65% through improvements in power conversion and grid interconnection technology, charger integration and modularity, and installation time.
Electrochaea employs a patented biocatalyst (BioCat) to convert low-cost and stranded electricity and CO 2 into pipeline-grade renewable gas. This gas can be directly injected into the existing natural gas grid or used immediately. Electrochaea’s proprietary biocatalyst is a selectively evolved—i.e.,
AC Propulsion and AutoPort , an automotive conversion, restyling and processing company, will partner in engineering, development and conversion to provide an Electric Vehicle conversion prototype and report for the United States Postal Service.
The US Department of Energy (DOE) Advanced Research Projects Agency-Energy (ARPA-E) will make up to $130 million available to develop five new program areas including biofuels, thermal storage, rare earth alternatives, grid controls, and solar power electronics. Related Funding Opportunity Announcements here.).
In collaboration with NE, DOE’s Hydrogen and Fuel Cell Technologies Office will provide funding and project oversight for the two hydrogen production–related projects that were selected: General Electric Global Research, Scaled Solid Oxide Co-Electrolysis for Low-Cost Syngas Synthesis from Nuclear Energy.
The US Energy Department’s Advanced Research Projects Agency-Energy (ARPA-E) has selected 14 projects for $27 million in funding to support the development of next-generation power conversion devices. High Quality, Low-Cost GaN Single Crystal Substrates for High Power Devices. High Quality, LowCost GaN Substrate Technology.
While both perceived and real safety risks due to the toxicity of NH 3 have detracted from its appeal, its adoption as a vector for H 2 has not yet been realized largely because of the absence of an efficient, low-cost method for cracking NH 3 to H 2 and N 2. —David et al. Although ammonia alone is difficult to ignite, a 2.5
Hydrokinetic energy is an abundant renewable resource that can boost grid resiliency and reduce infrastructure vulnerability, but it is currently a cost prohibitive option compared to other energy generating sources. The turbine will be designed for power delivery to remote and local grids. Emrgy, Inc. Emrgy, Inc.,
The new ARPA-E selections focus on accelerating innovations in clean technology while increasing US competitiveness in rare earth alternatives and breakthroughs in biofuels, thermal storage, grid controls, and solar power electronics. High Performance, LowCost Superconducting Wires and Coils. National Renewable. Corporation).
The third round is focused specifically on three technology areas: Grid-Scale Rampable Intermittent Dispatchable Storage (GRIDS). ARPA-E seeks to develop new technologies to enable the widespread deployment of cost-effective grid-scale energy storage. Agile Delivery of Electrical Power Technology (ADEPT).
The US Department of Energy announced $35 million in awards for 12 projects that find new ways to harness medium-voltage electricity for applications in industry, transportation, on the grid and beyond. GE Global Research, Inline Gas Discharge Tube Breaker for Meshed MVDC Grids – $4,350,686.
DE-FOA-0002784 Modification 06 ) Enabling widely available low-cost, high-performance superconducting (HTS) tapes could help enable the market growth and proliferation of nuclear fusion, superconducting cables for the electric grid, electric aviation, and superconductor-based electric generators/motors.
The goal is to develop energy storage systems with high-energy density to meet the ever-demand for the electric grid to provide reliable, distributed power. High-energy density magnesium batteries for smart electrical grids. Earlier post.) Mg-based electrolytes and other ionic electrolytes have also been developed and are being tested.
Unlike the electrode materials found in most lithium-ion batteries, Prussian blue enjoys a widespread availability and lowcost that make batteries based on Prussian blue electrodes an economically attractive, environmentally friendly technology. However, there are high electricity delivery costs for high power fast-charging stations.
The future grid will face significant challenges by providing clean power from intermittent resources to a much more dynamic load. To smooth out the intermittency of renewable energy production, low-cost electrical energy storage (EES) will become necessary. —Yang et al. flywheel) or potential energy (e.g.,
Researchers at the Department of Energy’s Oak Ridge National Laboratory have designed , fabricated and demonstrated a PHEV traction drive power electronics system that functions as the on-board charger, and that also provides significant mobile power generation and vehicle-to-grid support capabilities. 3923 - 3929 doi: 10.1109/ECCE.2009.5316496.
A key focus is developing and scaling new, low-cost manufacturing processes to catalyze increased domestic battery manufacturing for vehicle and stationary applications. DOE expects that applications for the manufacturing processes for battery energy storage subtopic will be Tier 2 for a total of up to $12,000,000 over 3 years.
billion to 21 projects to expand domestic manufacturing of batteries for electric vehicles (EVs) and the electrical grid and for materials and components currently imported from other countries. Albemarle is finalizing the site selection for the lithium hydroxide conversion plant in the southeastern United States. Earlier post.)
The researchers’ initial analysis suggests that the spiky textured surface of the catalysts provides ample reactive sites to facilitate the carbon dioxide-to-ethanol conversion. This could help to balance a grid supplied by intermittent renewable sources. —Adam Rondinone. Hensley, D. Bonnesen, P. Liang, L., Sumpter, B.
Natural Gas Reactor for Remote Chemical Conversion. sunlight through low-cost, plastic light-guiding sheets and then. Turbo-POx For Ultra Low-Cost Gasoline. conversion of natural gas to liquid fuels. combustor of a natural gas turbine, facilitating its conversion into a. If successful, this.
Bright Automotive launched eSolutions with a just-announced contract from the US Army TACOM to conduct a demonstration project on a low-cost plug-in hybrid electric solution for non-tactical military vehicles. Conversions. Tags: Conversions Hybrids Plug-ins. Bright Automotive, Inc., As part of the $1.4 Energy Storage.
Grid (non-storage) (0). In this topic, ARPA-E seeks to develop a new generation of ultra-high energy density, low-cost battery technologies for long electric range plug in hybrid electric vehicles and electric vehicles (EVs). Grid-Scale Rampable Intermittent Dispatchable Storage (GRIDS). Building Efficiency (9).
A residential smart charging pilot launching later this year that will reward customers in Colorado for conveniently optimizing their charging times to benefit the grid and use more renewable energy. Active conversations with a wide variety of partners to help achieve this 2030 EV vision.
The US Advanced Research Projects Agency - Energy (ARPA-E) is awarding $33 million to 13 new projects aimed at developing transformational fuel cell technologies for low-cost distributed power generation. MSRI’s technology will provide low-cost power while operating in a temperature range of 400-500 ?C, FuelCell Energy.
A key focus is developing and scaling new, low-cost manufacturing processes to catalyze increased domestic battery manufacturing for vehicle and stationary applications. Specific subtopics include: Accelerate the Manufacturing Process Design and Development Cycle for Advanced Energy Conversion and Storage Materials.
FedEx is also working with XL Hybrids, a developer of low-cost hybrid electric powertrain system, to convert ten conventionally-powered panel vans into more fuel-efficient, hybrid vehicles. In 2008, FedEx Corp.
The awards in this tranche focus on power electronics, grid-scale energy storage, and building efficiency; of the 43, three are categorized specifically for the automotive market—power electronics projects led by HRL Laboratories, LLC; Arkansas Power Electronics International, Inc.; and Case Western Reserve University. billion per year.
The function of the port is to convert AC power from the grid into DC, which is then applied to the battery. Within this circuit, a high-frequency transformer provides physical separation between grid power and the electric vehicles battery. For EVs, power conversion occurs in four stages (illustration, A shock hazard).
Polymer electrolyte membrane fuel cells (PEMFCs) are being developed worldwide as clean energy conversion devices. Long-Lived, High-Energy-Density and Low-Cost Lithium-Ion Batteries for Automotive, Grid Energy and Medical. Batteries for grid energy storage and medical devices have similar requirements.
Planar Na-beta Batteries for Renewable Integration and Grid Applications. Eagle Picher, in partnership with the Pacific Northwest National Laboratory, will develop a new generation of high energy, lowcost planar liquid sodium beta batteries for grid scale electrical power storage applications. Water (1 project).
The US Department of Energy (DOE) Advanced Research Projects Agency - Energy (ARPA-E) will award up to $30 million to fund a new program focused on the development of transformational electrochemical technologies to enable low-cost distributed power generation. DE-FOA-0001026 ). Source: ARPA-E. Click to enlarge. Source: ARPA-E.
FreeWire’s proprietary battery-integrated charging technology, Boost Charger, addresses grid constraints by packaging charging infrastructure, grid infrastructure, and energy storage into a fully-integrated compact solution.
Bloom’s customers have deployed the solution to lower and/or fix their energy costs, while significantly cutting their carbon footprints and enhancing their energy security by reducing their dependence on the grid. Solid State Energy Conversion Alliance (SECA). SOFCs operate at high temperature (typically above 800 °C).
Ecolectro is developing alkaline exchange ionomers (AEIs) to enable low-cost fuel cell and electrolyzer technologies. Developments from the project may be useful for other energy conversion technologies, such as ammonia production and high-temperature direct liquid fuel cells. University of California, San Diego.
ARPA-E requests innovative proposals which can overcome these challenges through the utilization of metabolic engineering and synthetic biological approaches for the efficient conversion of carbon dioxide to liquid transportation fuels. Batteries for Electrical Energy Storage in Transportation (BEEST).
LowCost Roll-to-Roll Manufacturing of Reusable Sorbents for Energy and Water Industries, $150,000 Qualification of SAS4A/SASSYS-1 for Sodium-Cooled Fast Reactor Authorization and Licensing, $674,484 Advanced Reactor Concepts LLC, Chevy Chase, Md. Touchstone Research Laboratory, Triadelphia, W. National Energy Technology Laboratory.
Specifically, the project will demonstrate a 50-kW capacitive wireless charging system with 150 kW/m 2 power transfer density and 95% efficiency, while meeting fringing-field safety standards and increasing grid reliability by minimizing power pulsations. Stanford University. The Ohio State University. University of Washington.
The goal is to develop an optimal generator for current energy conversion. This research into underwater coatings that prevent biofouling has the potential to positively impact all MHK systems and improve the conversion efficiency for MHK systems. DOE Funding: $160,000. Total Project Value: $192,000. DOE Funding: $160,000.
Saratoga Energy has won a National Science Foundation grant to scale up its breakthrough process for generating low-cost, top quality carbon nanotubes from carbon dioxide for use in making high-performance Li-ion batteries, such as those used in electric vehicles, grid storage, and military and aerospace applications.
We organize all of the trending information in your field so you don't have to. Join 5,000+ users and stay up to date on the latest articles your peers are reading.
You know about us, now we want to get to know you!
Let's personalize your content
Let's get even more personalized
We recognize your account from another site in our network, please click 'Send Email' below to continue with verifying your account and setting a password.
374 
Let's personalize your content