Green Car Congress

DECEMBER 22, 2019

LeMond Carbon announced the results of an independent technical audit conducted by Bureau Veritas (BV) of its carbon fiber manufacturing process. The audit was conducted on a pilot line at Deakin University’s Carbon Nexus facility in Geelong, Australia. This is a significant milestone for our company.

Carbon Fiber 221

Carbon Fiber Carbon Tennessee Universal 221

Green Car Congress

DECEMBER 4, 2020

Continental Structural Plastics (CSP) has fine-tuned its carbon fiber RTM (resin transfer molding) (CF-RTM) process to the point that a premium automaker will be using the technology for closures on future vehicle platforms. We have been targeting a 3-minute cycle time using 100 percent recycled carbon fiber.

Carbon Fiber 221

Carbon Fiber Carbon Portugal Production 221

Green Car Congress

JANUARY 5, 2018

(SoCalGas) is partnering with a development team to advance a new process that converts natural gas to hydrogen, carbon fiber, and carbon nanotubes. The technology commercialization team includes SoCalGas, C4, Pacific Northwest National Laboratory (PNNL) and West Virginia University (WVU).

Carbon Fiber 280

Carbon Fiber West Virginia Hydrogen Carbon 280

Green Car Congress

AUGUST 30, 2016

LeMond Composites, founded by three-time Tour de France champion Greg LeMond, has licensed a low-cost, high-volume carbon fiber manufacturing process developed at the US Department of Energy’s Oak Ridge National Laboratory (ORNL). Earlier post.)

Carbon Fiber 218

Carbon Fiber Low Cost Carbon Manufacturer 218

Green Car Congress

DECEMBER 20, 2011

signed a definitive agreement to form a joint venture to manufacture and commercialize carbon fiber and derivatives. The joint venture will develop and globally market a broad range of products and technical service support in the rapidly expanding carbon-fiber based composites industry.

Carbon Fiber 230

Carbon Fiber Carbon Turkey Wind 230

Green Car Congress

JULY 8, 2010

SGL Automotive Carbon Fibers—a joint venture of the BMW Group and SGL Group ( earlier post )— broke ground on the new greenfield carbon fiber manufacturing facility in Moses Lake, Washington. The plant will initially run two carbon fiber lines, each with annual capacity of 1,500 metric tons. Earlier post.)

Carbon Fiber 186

Carbon Fiber Washington Carbon BMW 186

Green Car Congress

AUGUST 22, 2013

The US Department of Energy (DOE) has issued a Request for Information (RFI) ( DE-FOA-0000975 ) regarding the state of technology development and commercial readiness of emerging renewable carbon fiber (RCF) technologies.

Carbon Fiber 186

Carbon Fiber Carbon Renewable Detroit 186

Green Car Congress

APRIL 6, 2010

SGL Automotive Carbon Fibers LLC, the joint venture between SGL Group and BMW Group ( earlier post ), will build a carbon fiber manufacturing plant in Moses Lake, WA. In the next step, the facility in Moses Lake will convert the polyacrylic fibers into the actual carbon fibers.

Carbon Fiber 220

Carbon Fiber BMW Carbon Building 220

Green Car Congress

MAY 20, 2013

MIT scientists demonstrated two approaches for growing CNTs on carbon fiber without degrading the fiber strength. Researchers at MIT have demonstrated two approaches for producing carbon fibers coated in carbon nanotubes without degrading the underlying fiber’s strength. Credit: ACS, Steiner et al.

Carbon Fiber 199

Carbon Fiber Carbon MIT Polymer 199

Green Car Congress

NOVEMBER 30, 2011

Teijin Limited will establish the first pilot plant for fully integrated production of carbon fiber reinforced thermoplastic (CFRTP) components from carbon fiber on the premises of its Matsuyama Factory in Ehime Prefecture, Japan.

Carbon Fiber 199

Carbon Fiber Carbon Production Automobile 199

Green Car Congress

DECEMBER 8, 2017

Acrylonitrile, a petroleum-derived commodity chemical, is one of the most widely used monomers in the chemical industry with many commercial applications. Today, acrylonitrile is used in the production of acrylic fibers for carpets, clothes, and fabrics, and in plastics such as food containers, and packaging materials.

Carbon Fiber 191

Carbon Fiber Renewable Carbon Eaton 191

Green Car Congress

JULY 26, 2020

Toray Industries concluded an agreement with Lilium GmbH to supply carbon fiber composite materials for the Lilium Jet. The aircraft’s primary structures, such as the fuselage, wings and flaps will all be made from carbon fiber. Carbon fiber composite materials are needed to lighten such vehicles as the Lilium Jet.

Carbon Fiber 186

Carbon Fiber Carbon All-Electric Supplies 186

Green Car Congress

MARCH 1, 2017

Lawrence Livermore National Laboratory (LLNL) researchers have become the first to 3D-print aerospace-grade carbon fiber composites, opening the door to greater control and optimization of the lightweight, yet stronger than steel material. Click to enlarge. —fluid analyst Yuliya Kanarska.

Carbon Fiber 150

Carbon Fiber Carbon Polymer Parts 150

Green Car Congress

FEBRUARY 20, 2021

Groupe Renault and Faurecia will collaborate on hydrogen storage systems for hydrogen-powered light commercial vehicles. Starting at the end of 2021, Faurecia will supply hydrogen storage systems for a first fleet of light commercial vehicles.

Hydrogen 305

Hydrogen Light Commercial France 305

Green Car Congress

NOVEMBER 18, 2009

Specifically, the funding will go toward reducing the production cost of carbon fiber manufacturing, to help in reducing the weight of vehicles; improved efficiency and lower costs for car batteries; and net-zero energy building technologies. Laboratories selected include: Oak Ridge National Laboratory (Oak Ridge, TN) will receive $34.7

Carbon Fiber 199

Carbon Fiber Carbon Building Manufacturer 199

Green Car Congress

JULY 24, 2013

Plasan Carbon Composites (PCC), a supplier of carbon fiber solutions to the automotive industry and a subsidiary of composites solutions pioneer Plasan Sasa, Inc, has partnered with Toray Industries to bring additional material and technology capabilities and solutions to its automotive and commercial customers.

Carbon Fiber 170

Carbon Fiber Carbon Market Shelby 170

Green Car Congress

MAY 20, 2016

Researchers led by a team from Oak Ridge National Laboratory (ORNL) have developed a new laser process that could make joining carbon fiber composites and aluminum for lightweight cars and other multi-material high-end products less expensive—as well as making the joints more robust. Adrian Sabau.

Carbon Fiber 170

Carbon Fiber Carbon Long Beach Polymer 170

Green Car Congress

FEBRUARY 22, 2015

Driven by a faster-than-expected pace of technology development, carbon-fiber reinforced plastics (CFRPs) will be poised to gain widespread adoption for automotive lightweighting by 2025, according to a new report from Lux Research, “Scaling Up Carbon Fiber: Roadmap to Automotive Adoption.”. Earlier post.)

Carbon Fiber 150

Carbon Fiber Carbon Automobile 2007 150

Green Car Congress

OCTOBER 13, 2016

PD Glasseiden, a Germany-based producer of fiberglass; European Carbon Fiber GmbH; and the ForschungsCampus Open Hybrid LabFactory e.V., In the first step at a location in Chemnitz, Saxony, CarboSax will build a pilot line for the sustainable production of carbon fibers.

Carbon Fiber 150

Carbon Fiber Germany Carbon Production 150

Green Car Congress

APRIL 17, 2015

Ford and DowAksa signed a joint development agreement (JDA) formally to advance research on cost-effective, high-volume manufacturing of automotive-grade carbon fiber, a material poised to play a significant role in the drive to make vehicles lighter. DowAksa is expanding on Aksa’s existing carbon fiber production assets.

Carbon Fiber 150

Carbon Fiber Carbon Ford Light 150

Green Car Congress

MAY 13, 2016

RMX Technologies and the Department of Energy’s Oak Ridge National Laboratory have signed an exclusive licensing agreement for a new technology that significantly reduces the time and energy needed in the production of carbon fiber. Oxidation is the most time-consuming phase of the multistep carbon fiber conversion process.

Carbon Fiber 150

Carbon Fiber Carbon Energy Production 150

Green Car Congress

JUNE 4, 2021

The practical new model has a range of more than 400 km (249 miles) (WLTP) and its three 700 bar carbon-fiber hydrogen tanks, which sit next to the battery under the front seats, can be filled in just three minutes. While accommodating this new technology, it retains its useful volume and load capacity. Available in two sizes, M (4.95

Hydrogen 493

Hydrogen Carbon Fiber Recharge Fuel 493

Green Car Congress

AUGUST 18, 2016

This new IACMI project will address both of these critical areas through a fundamentally different approach to the manufacturing of carbon fiber composites versus those currently in use today. High cycle time for production of continuous carbon fiber thermoplastic composites increases costs.

Carbon Fiber 150

Carbon Fiber Carbon Universal Tennessee 150

Green Car Congress

MAY 19, 2015

The collaborative project is intended ultimately to set the stage for innovative breakthroughs in future commercial automobiles. Mustang engine, used a combination of carbon fiber, Torlon, epoxy, ceramic and metal. The original Polimotor was developed by Matti Holtzberg in the 1980s. liter Duratec engine.

Carbon Fiber 150

Carbon Fiber Polymer Carbon Engine 150

Green Car Congress

MARCH 24, 2016

Researchers at the Department of Energy’s Oak Ridge National Laboratory have demonstrated a production method they estimate will reduce the cost of carbon fiber as much as 50% and the energy used in its production by more than 60%. Details of the cost analysis will be shared with the prospective licensees.

Carbon Fiber 150

Carbon Fiber Carbon Manufacturer Energy 150

Green Car Congress

SEPTEMBER 28, 2016

A team at Sun Yat-sen University in China has developed new high-performance, stable cathode for Li-S batteries consisting of a 3D activated carbon fiber matrix (ACFC) and sulfur. For the composite cathodes with 3D conductive framework, however, the continuous carbon fibers act as high-speed electron pathway.

Carbon Fiber 150

Carbon Fiber Carbon Li-ion Battery 150

Green Car Congress

JUNE 24, 2020

NPROXX was formed in 2018 in a split from EMS, a leading supplier of high-quality carbon fiber products and specialist manufacturing services. When used for hydrogen storage in hydrogen fuel-cell trucks or buses, these carbon fiber-reinforced vessels can result in a weight reduction in the gas containment system.

Hydrogen 418

Hydrogen Carbon Fiber Fuel Gas 418

Green Car Congress

OCTOBER 4, 2009

The 2015 date for fuel cell vehicles reinforced remarks made in June by vice president Masatami Takimoto about commercialization prospects.( As an example, Yokoyama used the carbon fiber reinforced polymer (CFRP) hydrogen storage tank. Toyoda positioned EVs for short-distance travel and fuel cell cars for longer ranges.

2015 315

2015 Toyota Commercial Fuel 315

Green Car Congress

OCTOBER 10, 2021

MetalKraft Technologies, with members from Lehigh University, also is using solid phase processing to create Copper-Graphene Ultra Wire with small amounts of commercially available low-defect crystalline Graphene.

Manufacturer 320

Manufacturer Carbon Fiber Carbon Affordable 320

Green Car Congress

MAY 14, 2023

Ford Pro, the company’s commercial vehicle (CV) and services division, will use the pilot to expand its conversion expertise, supported by on-site engineers and E-Transit specialists from the company’s Dagenham site and Dunton Technical Centre, in Essex, UK.

Hydrogen 434

Hydrogen Ford Fuel Carbon Fiber 434

Green Car Congress

OCTOBER 27, 2014

The prototype currently reaches the same voltage as a commercially available AA battery. Researchers in Sweden are exploring the use of carbon fiber as an active electrode in a multifunctional structural Li-ion battery in an electric car; i.e., electrical storage is incorporated into the body of the car. Click to enlarge.

Battery 362

Battery Batteries Carbon Fiber San Diego 362

Green Car Congress

DECEMBER 12, 2011

Compressed hydrogen storage provides a near-term pathway to commercialization, and reducing the costs of compressed tank systems will accelerate their market availability and adoption. DOE’s Pacific Northwest National Laboratory, in collaboration with Ford Motor Company, Lincoln Composites, Toray Carbon Fibers America, Inc.

Hydrogen 330

Hydrogen Carbon Fiber Oregon Alabama 330

Green Car Congress

OCTOBER 29, 2014

the core company of the Teijin Group’s carbon fibers and composites business, has developed a new technology—Tenax Part via Preform (PvP)—for highly efficient production of thermoset carbon fiber-reinforced plastic (CFRP). Toho Tenax Co., Expensive intermediate steps are not necessary.

Carbon Fiber 218

Carbon Fiber Production Carbon Waste 218

Green Car Congress

DECEMBER 30, 2022

Asphaltenes are thus deemed as low-value by-products with little to no real-world application and commercial use in today’s market. To date, efforts have been invested in developing carbon fibers, carbon electrodes, porous carbon foam/scaffolds, and carbon nanosheets from asphaltenes.

Waste 492

Waste Manufacturer Carbon Fiber Polymer 492

Green Car Congress

JANUARY 16, 2015

Researchers from Nanjing Forestry University and the University of Maryland have designed high-performance microfibers by hybridizing two-dimensional (2D) graphene oxide (GO) nanosheets and one-dimensional (1D) nanofibrillated cellulose (NFC) fibers. Note that the infiltrated GO–NFC microfibers were also lightweight in nature.

Carbon Fiber 150

Carbon Fiber Li-ion Hybrid Carbon 150

Green Car Congress

JANUARY 18, 2014

VTO is seeking projects that address the major challenges to developing and commercializing batteries for plug?in As described in multiple DOE reports, the main barriers to widespread PEV commercialization are the cost; performance and life; and abuse tolerance of high?energy competitive, commercially viable after?treatment

Carbon Fiber 252

Carbon Fiber Engine Battery Powered Fuel 252

Green Car Congress

APRIL 28, 2010

has signed a Joint Development Agreement (JDA) with Daimler AG to develop automobile parts made of carbon fiber reinforced plastics (CFRP). As the world’s largest manufacturer of carbon fiber, Toray has identified expansion of its Carbon Fiber Composite Materials Business in the automotive field as one of its top priorities.

Automobile 210

Automobile Carbon Fiber Parts Mercedes 210